audio-technica ATCS-A60RX

ATCS-A60RX

LONG RANGE INFRARED RECEIVERS

In the digital era, safeguarding of sensitive data and information is paramount. With Audio-Technica's infrared conference system your wireless signal will not leave the room; it is impossible to capture from another building, for example. Compared to a UHF system which uses radio waves that behave in the same way as a radio station transmitting over a broad area, the infrared system excels at protecting your information, as no leakage is possible.

• Works with the ATCS-A60TX transmitter and the ATCS-A60MX mixer
• Expands the operational area of infrared transmission and reception in a very large room, or in a room with a high ceiling
• The ATCS-A60MX can control up to four A60TX infrared transmitters and four A60RX infrared receivers
• In a very large room, the system can manage up to 4 A60MX controllers for a total of 16 A60RX receivers and 16 A60TX transmitters
• The joint use of A60RX and its dedicated antennas can extend the emission of the infrared signal within a room by up to 20m
• Infrared transmission keeps the information inside of the room
• Multiple conference systems can thus be used simultaneously in adjacent rooms while ensuring the protection of your data
• The A60RX receiver is equipped with a 1/4" thread mount to allow quick and easy installation on a camera tripod, the wall or the ceiling
• Connects via a 75Ω BNC coaxial cable to the ATCS-A60MX controller

“KEEP YOUR CONFIDENTIAL INFORMATION PRIVATE”

By its very nature, infrared technology is secure, guaranteed to keep you and your confidential information in the conference room only. No information can be received outside of the room.

“UP TO 16 TRANSMITTERS AND 16 RECEIVERS PER ROOM”

When designing the system for use in an extremely large room, the ATCS-60 system coupled to the ATCS-A60MX controller can control up to 16 transmitters and 16 receivers. This allows you to increase the operational area of the room.

“SELF-POWERED RECEIVER”

The ATSC-A 60RX receiver is continuously powered by a 24 Volt DC, provided by the ATCS-A60MX controller which is connected to it via a BNC 75 Ohm coaxial cable. Using a 5C2V cable or higher is required.